About Rustic Roots Warehouse
You are deciding if a wide live edge top will stay flat in your house. Live Edge Slabs in Stallings homes face muggy summers and drier winter heat, even with the air conditioning on. So we acclimate and finish the slab for that swing before it becomes a table.
We mill our own material and qualifying customer logs. Because a wet slab will move once the heat runs, we slow the job.
Always Growing. Always Creating.
Live Edge Slabs in Stallings Through a Humid Summer
Wood takes on moisture across the grain. When the air stays muggy, a wide top grows in width. Then winter heat pulls moisture back out, and the top shrinks.
In Stallings, that swing shows up in air-conditioned houses. We have seen tops cup when one face dried faster than the other. A finish on the top face only leaves the underside free to move.
Where the Work Begins
Sawmill and lumber work starts the job, then the shop follows a short order.
- We pick from inventory or mill a qualifying log, and wide logs go on the Lucas Mill.
- Air drying or a kiln run brings the moisture down for indoor air.
- Flattening comes next, then finish on both faces and the edges.
- The base lets the top move a little across the grain.
After that, the top still needs time in the room.
Shaped by Nature. Finished by Hand.
Finish choice changes the care you do at home. A film finish, such as varnish, sheds a short spill. An oil looks dull when it needs another coat, and it lets more moisture through.
For a dining top, a film finish takes a glass and a wipe, and both faces still get the same coats. For a mantel, an oil can be enough out of the splash zone.
A Resource for Ideas of Every Size
Shop Time for Live Edge Slabs in Stallings
A wipe-down and a look under the top take an evening at home. A cupped top can mean a shop visit. People from Stallings have brought us photos first.
When we take a top back, we check moisture and fasteners. Then we flatten only if the cup is past what a finish refresh will hide. We write the quote out line by line.
More to Discover Around Every Corner
When humid weeks stack up, look along the live edge for a new gap at the wall. Then check the underside if you can’t reach it. A wet cloth left overnight keeps that spot damper than the rest of the slab.
So wipe a spill the same day. You can look through our live edge slabs work if you are still choosing a build.
See What We’ve Been Creating
People in older houses have told us an upstairs room stays closer to the outdoor air. But in newer houses the cooling can pull a room drier while it runs. When a slab sits over a floor vent, it takes more of that dry air. We have had calls about a top that cupped over a winter register. We have had people slide the table a few feet off that vent.
Planning an Outdoor Project?
Porch Care for Live Edge Slabs in Stallings
In Stallings, porch air stays damper than the air in a dining room. A screened porch does that too. We have built benches for covered outdoor spots, and those need a weather finish.
After a wet week, let a bench shed water under cover before it sits by a heat run. We have seen cupping on benches that sat half in sun.
People have called about Live Edge Slabs in Stallings after a hot spell. A top cupped, then eased once the air dried. Some calls were about a finish that opened along the live edge.
A small check at the end is common on wide stock. A check that grows in the house needs a look. Because it can mean the top is still losing moisture. It can also mean the fasteners are too tight.
Come See What’s Taking Root
If you are choosing a new piece, ask how that species moves in damp air and in dry heat. Then look at slabs on hand and at the finishes before you decide. When epoxy fills a void, ask us how the wood around it will move with the seasons.
Live Edge Slabs in Stallings houses do better when the drying matches the room. Customer kiln loads start at a 500-board-foot minimum if you’re drying your own logs.